Health Vidya

GENERAL RECOMMENDATIONS1. Use teat dip applicators made of plastic or other non-corrosive materials. Do not use cups made of aluminum.2. When solution in the teat dip cup becomes dirty and/or noticeably loses color, discard remaining contents and refill cup with fresh teat dip.3. Do not use this product for cleaning or sanitizing equipment.4. Wash Teat Dip cups after each milking. RECOMMENDED PROCEDURES FOR TEAT SANITATION A. PRE-MILKING (PRE-DIPPING) 1. REMOVE VISIBLE SOILS FROM THE TEATS.2. OBSERVE FOREMILK BY STRIPPING TWO OR THREE STREAMS OF MILK INTO A STRIP CUP.3. DIP OR SPRAY THE COW'S TEATS FULL LENGTH WITH FS-104-X TEAT DIP.4. WAIT APPROXIMATELY 30 SECONDS.5. REMOVE ALL TEAT DIP BY THOROUGHLY DRYING THE TEATS AND TEAT ORIFICES WITH A CLEAN, SINGLE SERVICE PAPER TOWEL(S).6. ATTACH MILKING UNIT. B. POST-MILKING (POST-DIPPING) Immediately after milking, dip or spray all teats full length with FS-104 X Teat Dip Ensure good coverage of all sides of the teats and teat orifices. A PART OF THE COMPLETE IBA SANITATION PROGRAM